Dle 111cc manual

Login here. Please contact us and let us learn your situation first before return the item. Check our Policy. We never miss message in support flight-model. RC Parts Source Never get lost.

Your email. Create your account Lost password? First name. Last name. Alloy Model Airplane Vehicle. Propellers wood propellers carbon fiber propellers 3D aerobatic propellers multiblades propellers propeller holder.

Spinner aluminum spinner plastic spinner carbon fiber spinner multiblades spinner. Wheels and Related wheels tires tail wheels.

Landing Gear carbon fiber landing gear retractable landing gear anti-vibration landing gear. Fuel Tanks. Wing Bags. If the engine can't start for reasons of quality problem , we will provide components to dealers , and dealers will repair it. Skip to content. DLE Installation Dimension. Operator's Manual. Operator's Manual for DLE Three-dimensional diagram. Three-dimensional diagram for DLE Even though it may look good from the outside, it may be cracked on the inside which may cause it to disintegrate while in use.

Do not use a nicked, cracked or split propeller. Use gasoline approved rubber fuel line. Always secure the fuel line away from the cylinder head. The engine will be hot. A high quality synthetic 2-cycle oil is recommended for optimum performance and a longer engine life. Synthetic 2-cycle oils leave fewer combustion byproducts than natural oil which can foul the engine and exhaust ports, resulting in reduced performance. Do this by running the engine at idle until it quits by running out of fuel.

Keeping gasoline inside the carburetor over an extended period of time will damage the diaphragm valve and clog passages inside the carburetor.

Do not attempt to use it for any other purpose. Doing so could cause radio interference. Pay close attention to the High-speed Needle adjustment. Running the engine with the proper gas mixing will cause the spark plugs to appear yellow at the ignition point.

Check to see that all screws and bolts are tight. Check carefully for any cracks, broken or missing parts. Tighten or replace any damaged or missing parts before proceeding. Install the silicone wire cover over the pick up lead coming from the engine cut the excess silicon wire cover and connect the lead to the pick—up lead from the Electronic Ignition Module. Secure the connection with the included three pin connector securing clip. Connect the kill switch lead to the red connector from the ignition.

Use one of the included three pin securing clips to secure the connection. Connect the ignition module battery to the kill switch. Any 4. Use heat shrink tubing to secure this connection.