Netgear wg602 v3 manual

Network repeating allows two distant sections of a wireless network to communicate. In this example, the solid lines are a wired connection, the dotted line is the repeating link between access points, and the lightning bolt is a wireless station such as a laptop. The two access points are configured similarly.

If you use a MAC control list on one access point, then use it on the other, too. Advanced remote support tools are used to fix issues on any of your devices. The service includes support for the following:. Thank You Thank you for taking the time to respond. Rating Submitted Do you have a suggestion for improving this article? Characters Left : Submit Cancel. Get information, documentation, videos and more for your specific product.

Ask the Community. Need to Contact Support? Configure the computer with a static IP address of. Turn on your computer, connect the power adapter to the. WG and verify the following:. The power power light goes on. When prompted, enter admin for the user name and password for the password, both in lower case letters. Configure the wireless interface for wireless access. See the. Note: You must set the Regulatory Domain. It may not be legal. Now that you have finished the setup steps, you are ready to deploy the WG in your network.

Deploy the WG Access Point. Disconnect the WG and position it where you will deploy it. The best location is elevated at the center of your wireless coverage area. Lift the antenna so that it is vertical.